The Specialists in ESD Protection
000 Checkout

Added to your cart

You do not have any items in your shopping cart at this time.
View All cart items
Full Catalog > Meters and Measurement > Resistance Testers > Cylinder Probes >
ESD protected area products should be tested:
1. Prior to installation to qualify product for listing in user's ESD control plan.
2. During initial installation.
3. For periodic checks of installed products as part of IEC 61340-5-1 Edition 1 2007-08 clause 5.2.3 Compliance verification plan.

As ESD floor and working surface matting get dirty which can increase their resistance. It is therefore recommended to check ESD surfaces regularly using a resistance checker. 

The Vermason Cylindrical Probes are to be used in conjunction with a resistance meter to measure point-to-point resistance, volume resistance, and resistance to ground in accordance with EN 61340-5. The probe has non-marking highly conductive pads. A cap is supplied with the probes that protects the pad when not in use. The insulating jacket and shape aid grip - insulation resistance is approximately 1 x 106 ohms.

Need a Demo – Request it Here



Total Number of Items in Category: 2

1